HiTechnic Servo Controller email PDF Print E-mail
Written by Jamie Diamond   
Wednesday, 01 October 2014 22:07
Hi Jamie,
I just talked to our engineer and got some details.
The servo voltage is 6V. The current limit is 5A shared between all 6 servos that are attached. In other words, the 800mA limit that you are getting from FIRST is based on all 6 servos being stalled at the same time. If only one servo is stalled and active, than all 5A can go to that one servo.

I also verified that the 5A limit is protected in the controller and it will shut down if exceeded.

Best Regards,
HiTechnic Support
 
Copyright © 2017 cougarrobot.com. All Rights Reserved.
Joomla! is Free Software released under the GNU/GPL License.